User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 589 System Manual
3.8.17.2 Restoring the Default Values of Bearer Interface Parametes
To restore the default values of some or all of the Bearer Interface parameters, run
the following command:
npu(config-bs-66053)# no bearer [mtu-size] [linkusage-hardthrshld]
[bearer-vlan]
You can restore only one or two parameters to the default values by specifying
only these parameters. For example, to restore only the mtu-size parameter to the
default value, run the following command:
npu(config-bs-66053)# no bearer mtu-size
This parameter will be restored to its default value, while the other parameters
will remain unchanged.
To restore all Bearer Interface parameters to their default value, run the following
command:
npu(config-bs-66053)# no bearer
[bearer-vlan <(9 to 9
StepSize 1) | (11 to 100
StepSize 1) |(110 to 4094
StepSize 1)> ]
The VLAN ID of the
bearer interface of the
BS.
Must be equal to the
VLAN ID of the Bearer
interface (see
Section 3.3.2.3.5)
Optional 11 9, 11-100,
110-4094.
Command
Modes
bs configuration mode
IMPORTANT
When creating a new BS, the Bearer Interface mandatory parameters must be configured.
NOTE
Refer to Section 3.8.17.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053)# no bearer [mtu-size ] [linkusage-hardthrshld ]
[bearer-vlan ]