User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 575 System Manual
3.8.16.4 Terminating the Airframe Configuration Mode
Run the following command to terminate the Airframe configuration mode:
npu(config-bs-66053-airframe)# exit
3.8.16.5 Displaying Configuration Information for Airframe
Parameters
You can display the current configuration information for the following Airframe
parameters tables:
 General (refer to Section 3.8.16.5.1)
 Map Zone (refer to Section 3.8.16.5.2)
 Downlink Diversity (refer to Section 3.8.16.5.3)
Command
Syntax
npu(config-bs-66053-airframe)# no mimo [first-zone-min-size ]
[first-zone-max-size ] [max-map-size ] [bcast-msgzone-loc ]
Privilege
Level
10
Command
Modes
bs airframe configuration mode
IMPORTANT
Do not forget to execute the apply command before terminating the Airframe configuration mode:
npu(config-bs-66053-airframe)# apply
Command
Syntax
npu(config-bs-66053-airframe)# exit
Privilege
Level
10
Command
Modes
bs airframe configuration mode