User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 572 System Manual
3.8.16.3.2 Restoring the Default Values of Airframe Map Zone Parameters
To restore one or all of the Airframe Map Zone non-mandatory parameters to their
default values, run the following command:
npu(config-bs-66053-airframe)# no mapzone [size] [repetition]
You can restore only one parameter to the default value by specifying only that
parameter. For example, to restore only the size parameter to the default value,
run the following command:
npu(config-bs-66053-airframe)# no mapzone size
The parameter will be restored to its default value, while the other parameter will
remain unchanged.
To restore all non-mandatory parameters to their default value, run the following
command:
npu(config-bs-66053-airframe)# no mapzone
NOTE
Refer to Section 3.8.16.2.1 for a description and default values of the parameter.
Command
Syntax
npu(config-bs-66053-airframe)# no general [preamble-grp ]
Privilege
Level
10
Command
Modes
bs airframe configuration mode
NOTE
Refer to Section 3.8.16.2.2 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-airframe)# no mapzone [size ] [repetition ]