User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 566 System Manual
3.8.16.2.7 Configuring Airframe Dynamic Permutation Parameters
To configure the Airframe Dynamic Permutation parameters, run the following
command:
npu(config-bs-66053-airframe)# dynamicperm [dl-permbase {TRUE | FALSE}]
[ul-permbase {TRUE | FALSE}]]
Command
Syntax
npu(config-bs-66053-airframe)# uldatazone [permbase <(0 to 69
StepSize 1)> ] [startallocation <(0 to 209 StepSize 1)> ]
[subchannels-number <(1 to 35 StepSize 1)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[permbase <(0 to 69
StepSize 1)> ]
The permutation base
used in the uplink
datazone
Optional 0 to 69 in steps
of 1
[startallocation <(0 to
209 StepSize 1)> ]
The start allocation for the
uplink datazone in slots.
In the current release the
value is hard-coded (0). An
attempt to set a different
value will be ignored.
Optional 0 0 to 209 in
steps of 1
[subchannels-number
<(1 to 35 StepSize 1)>
]
The number of
subchannels used in the
uplink datazone.
n the current release the
value is set internally: If
bandwidth=7MHz or
10MHz, value is set to 35.
If bandwidth=5MHz, value
is set to 17. An attempt to
set a different value will be
ignored.
Optional 35
default
value=35
(7 , 10
MHz) or
17 (5MHz)
1- 35
Command
Modes
bs airframe configuration mode