User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 564 System Manual
3.8.16.2.5 Configuring Airframe Downlink Data Zone Parameters
To configure the Airframe Downlink Data Zone parameters, run the following
command:
npu(config-bs-66053-airframe)# dldatazone [subchannels <(1 to 30 StepSize
1)>] [permbase <(0 to 31 StepSize 1)>]
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[subchannels <(1 to
35 StepSize 1)> ]
The number of subchannels
used in the uplink feedback
zone.
In the current release the
value is set internally: If
bandwidth=7MHz or
10MHz, value is set to 35. If
bandwidth=5MHz, value is
set to 17. An attempt to set
a different value will be
ignored.
Optional 35 11-35
[permbase <(0 to 69
StepSize 1)> ]
The permutation base used
in the feedback zone
Mandatory
when
creating a
new BS.
N/A 0 - 69
Command
Modes
bs airframe configuration mode
NOTE
An attempt to configure the subchannels parameter will be ignored. The value of this parameter is
set by internal logic according to the configured bandwidth.
IMPORTANT
When creating a new BS, the Airframe Uplink Feedback Zone mandatory parameters must be
configured.
Command
Syntax
npu(config-bs-66053-airframe)# dldatazone [subchannels <(1 to 30
StepSize 1)> ] [permbase <(0 to 31 StepSize 1)> ]