User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 558 System Manual
In addition, you can, at any time, display configuration information for each of the
Airframe parameters tables (refer to Section 3.8.16.5).
3.8.16.1 Enabling the Airframe Configuration Mode
To configure the Airframe parameters, first enable the Airframe configuration
mode. Run the following command to enable the Airframe configuration mode.
npu(config-bs-66053)# airframe
After enabling the Airframe configuration mode, you can execute any of the
following tasks:
 Configure one or more of the Airframe parameters tables (refer to
Section 3.8.16.2)
 Restore the default values of parameters in one or more of the Airframe
parameters tables (refer to Section 3.8.16.3)
After executing the above tasks, you can terminate the Airframe configuration
mode (refer to Section 3.8.16.4) and return to the BS configuration mode.
Note that for properly completing the Airframe configuration the apply command
must be executed prior to exiting the Airframe configuration mode.
3.8.16.2 Configuring Airframe Parameters
After enabling the Airframe configuration mode you can configure the following
parameters tables:
 General (refer to Section 3.8.16.2.1)
 Map Zone (refer to Section 3.8.16.2.2)
Command
Syntax
npu(config-bs-66053)# airframe
Privilege
Level
10
Command
Modes
bs configuration mode