User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 555 System Manual
You can display configuration information for the Baseband bandwidth parameter
of a selected or all existing BSs (refer to Section 3.8.15.2).
3.8.15.1 Configuring the Baseband Bandwidth Parameter
From the BS configuration mode, run the following command:
npu(config-bs-66053)# baseband [bandwidth {fiveMHz | tenMHz | sevenMHz}]
Note that the valid value ranges (and in some cases also default value) of certain
parameters are affected by the value configured for the bandwidth parameter. If
you change the bandwidth, verify that these parameters are configured properly:
To configure the Baseband bandwidth parameter:
Command
Syntax
npu(config-bs-66053)# baseband [bandwidth {fiveMHz | tenMHz |
sevenMHz} ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[bandwidth {fiveMHz |
tenMHz | sevenMHz} ]
BS channel
bandwidth
Mandatory N/A
 fiveMHz
 tenMHz
 sevenMHz
Command
Modes
bs configuration mode
IMPORTANT
When creating a new BS, the mandatory frequency parameter must be configured.
Table Parameters
RF (see
Section 3.8.14.1) frequency