User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 552 System Manual
3.8.14 Managing the RF Frequency Parameter
After enabling the BS configuration mode, you can configure the RF frequency
parameter (refer to Section 3.8.14.1).
You can display configuration information for the RF frequency parameter of a
selected or all existing BSs (refer to Section 3.8.14.2).
3.8.14.1 Configuring the RF Frequency Parameter
From the BS configuration mode, run the following command:
npu(config-bs-66053)# rf [frequency <(2022.5 to 2217.5 StepSize 0.125) |
(2302.5 to 2397.5 StepSize 0.125) | (2487.5 to 2687.5 StepSize 0.125) | (3302.5
to 3397.5 StepSize 0.125) | (3402.5 to 3597.5 StepSize 0.125) | (3602.5 to 3797.5
StepSize 0.125)>]
bs-id-lsb <(1 to
16777215
StepSize 1)>
The Neighbour BS ID.
Specify a value for this
parameter if you want to
display the Trigger Setup
parameters of a specific
Neighbour BS in a specific
BS. Do not specify a value for
this parameter if you want to
display the Trigger Setup
parameters of all Neighbour
BSs in all BSs.
Optional N/A 1-16777215
Command
Modes
Global command mode
To configure the RF frequency parameter:
Command
Syntax
npu(config-bs-66053)# rf [frequency <((2022.5 to 2217.5 StepSize
0.125) | (2302.5 to 2397.5 StepSize 0.125) | (2487.5 to 2687.5
StepSize 0.125) | (3302.5 to 3397.5 StepSize 0.125) | (3402.5 to
3597.5 StepSize 0.125) | (3602.5 to 3797.5 StepSize 0.125)>]
Privilege
Level
10