User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 538 System Manual
To restore all Neighbor BS Trigger Setup parameters to their default value, run the
following command:
npu(config-bs-66053-nbr-68000)# no triggersetup
3.8.13.4 Deleting Neighbor BS Triggers/Specific BS Triggers
After enabling the Neighbor BS configuration mode you can delete previously
configured triggers or specific BS triggers:
3.8.13.4.1 Deleting Neighbor BS Triggers
To delete an entry from the neighbor BS triggers table run the following command:
npu(config-bs-66053-nbr-68000)# no <trigger-name>
NOTE
Refer to Section 3.8.13.2.3 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-nbr-68000)# no triggersetup [avgduration-rssi]
[avgduration-cinr] [avgduration-rtd ]
Privilege
Level
10
Command
Modes
bs neighbour bs configuration mode
NOTE
Refer to Table 3-31 for a description and possible values of the triggers.
Command
Syntax
npu(config-bs-66053-nbr-68000)# no <trigger-name>
Privilege
Level
10
Command
Modes
bs neighbour bs configuration mode