User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 537 System Manual
You can restore only some parameters to their default values by specifying only
those parameter. For example, to restore only the ack and cqi parameters to the
default values, run the following command:
npu(config-bs-66053-nbr-68000)# no requiredcnr ack cqi
These parameters will be restored to their default value, while the other
parameters will remain unchanged.
To restore all Neighbor BS Required C/N Levels parameters to their default value,
run the following command:
npu(config-bs-66053-nbr-68000)# no requiredcnr
3.8.13.3.3 Restoring the Default Values of Neighbor BS Trigger Setup Parameters
To restore some or all of the Neighbor BS Trigger Setup parameters to their default
values, run the following command:
npu(config-bs-66053-nbr-68000)# no triggersetup [avgduration-rssi]
[avgduration-cinr] [avgduration-rtd]
You can restore only some parameters to their default values by specifying only
those parameters. For example, to restore only the avgduration-cinr parameter to
the default value, run the following command:
npu(config-bs-66053-nbr-68000)# no triggersetup avgduration-cinr
This parameter will be restored to its default value, while the other parameters
will remain unchanged.
NOTE
Refer to Section 3.8.13.2.2 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-nbr-68000)# no requiredcnr [ack ] [cqi ] [cdma
] [qpsk-1by2 ] [qpsk-3by4 ] [qam16-1by2 ] [qam16-3by4 ]
[qam64-1by2 ] [qam64-2by3 ] [qam64-3by4 ] [qam64-5by6 ]
Privilege
Level
10
Command
Modes
bs neighbour bs configuration mode