User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 518 System Manual
You can display configuration information for the Scan Negotiation parameters of
a selected or all existing BSs (refer to Section 3.8.11.3).
3.8.11.1 Configuring Scan Negotiation Parameters
From the BS configuration mode, run the following command:
npu(config-bs-66053)# scanning [ienable-modify {true | false}]
3.8.11.2 Restoring the Default Value of Scan Negotiation Parameters
To restore the Scan Negotiation enable-modify parameter to the default value, run
the following command:
npu(config-bs-66053)# no scanning [enable-modify]
To configure the Scan Negotiation Parameters:
Command
Syntax
npu(config-bs-66053)# scanning [enable-modify {true | false} ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[enable-modify {TRUE
| FALSE} ]
Determines whether the
BS will modify unfeasible
scan profiles requested by
MSs.
Note: If TRUE the BS will
modify unfeasible scan
profile requests and if
FALSE the BS will deny
the requests.
Optional true
 true
 false
Command
Modes
bs configuration mode