User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 506 System Manual
3.8.7.2 Restoring the Default Values of Feedback Allocation
Parameters
To restore the ir-cdma non-mandatory parameter to the default values, run the
following command:
npu(config-bs-66053)# no feedbackalloc [ir-cdma]
You can restore only one parameter to the default value by specifying only this
parameter. For example, to restore only the ir-cdma parameter to the default
value, run the following command:
npu(config-bs-66053)# no feedbackalloc ir-cdma
This parameter will be restored to the default value, while the other parameter will
remain unchanged.
To restore all Feedback Allocation non-mandatory parameters to their default
value, run the following command:
npu(config-bs-66053)# no feedbackalloc
3.8.7.3 Displaying Configuration Information for Feedback
Allocation Parameters
To display configuration information for Feedback Allocation parameters, run the
following command:
Command
Modes
bs configuration mode
NOTE
Refer to Section 3.8.7.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053)# no feedbackalloc [ir-cdma ]
Privilege
Level
10
Command
Modes
bs configuration mode