User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 497 System Manual
3.8.6.3 Restoring Default Values for Power Control Configuration
Parameters
After enabling the Power Control configuration mode you can restore the default
values for parameters in the following parameters tables:
 Noise and Interference Level (refer to Section 3.8.6.3.1)
 Required C/N Level (refer to Section 3.8.6.3.2)
3.8.6.3.1 Restoring the Default Values of Power Control Target Noise and
Interference Level Parameters
To restore one or all of the Target Noise and Interference Level parameters to their
default values, run the following command:
npu(config-bs-66053-pwrctrl)# no nilevels [cqi-ack-ranging] [pusc]
[power-control-correction-factor]
You can restore only one parameter to its default values by specifying only that
parameter. For example, to restore only the pusc to the default value, run the
following command:
npu(config-bs-66053-pwrctrl)# no nilevels pusc
The parameter will be restored to its default value, while the other parameters will
remain unchanged.
To restore all Target Noise and Interference Level parameters to their default
value, run the following command:
npu(config-bs-66053-pwrctrl)# no nilevels
NOTE
In the current release, the command for restoring the default value for the Maximum EIRxP
parameter, npu(config-bs-66053-pwrctrl)# no maxeirxp, is not applicable and should not be used.
An attempt torestore the value to a default value using this command will be ignored (value is taken
from vendor file).
NOTE
Refer to Section 3.8.6.2.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-pwrctrl)# no nilevels [cqi-ack-ranging ]
[pusc] [power-control-correction-factor]