User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration

4Motion 371 System Manual

4Motion system, where each entry is uniquely identified by the pair of values for

the Read Community and Write Community. This section describes the

commands to be executed for:

 “Adding an SNMP Manager” on page 371

 “Deleting an Entry for the SNMP Manager” on page 372

 “Displaying Configuration Information for SNMP Managers” on page 373

3.3.14.1.1 Adding an SNMP Manager

You can configure upto five SNMP Managers. To add an SNMP Manager, run the

following command:

npu(config)# snmp-mgr [ReadCommunity <string>] [ReadWriteCommunity

<string>]

You can display configuration information for existing SNMP Managers. For

details, refer Section 3.3.14.1.3.

NOTE

An existing SNMP Manager entry cannot be modify. To modify the parameters of an SNMP

Manager, delete the entry and add a new entry with the required parameters.

IMPORTANT

An error may occur if you have specified:

 More than five entries for the SNMP Manager

 Duplicate entries (an snmp-mgr entry is uniquely identified by values for "ReadCommunity" and

"WriteCommunity")

Command

Syntax

npu(config)# snmp-mgr [ReadCommunity <string>] [ReadWriteCommunity

<string>]

Privilege

Level