User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 482 System Manual
To restore all R6 Profile parameters to their default value, run the following
command:
npu(config-bs-66053-srvcmaprule-1)# no r6prof
3.8.5.4 Terminating the Service Mapping Rule Configuration Mode
Run the following command to terminate the Service Mapping Rule configuration
mode:
npu(config-bs-66053-srvcmaprule-1)# exit
NOTE
Refer to Section 3.8.5.2.4 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-srvcmaprule-1)# no r6prof [datadeliverytype ]
[priority ] [mediaflowtype ] [use-mediaflowtype] [mir ] [cir ]
[latency ]
Privilege
Level
10
Command
Modes
bs service mapping rule configuration mode
IMPORTANT
Do not forget to execute the apply command before terminating the BS Service Mapping Rule
configuration mode:
npu(config-bs-66053-srvcmaprule-1)# apply
Command
Syntax
npu(config-bs-66053-servmaprule-1)# exit
Privilege
Level
10
Command
Modes
bs service mapping rule configuration mode