User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 468 System Manual
3.8.4.3 Restoring Default Values for BS Service Parameters
After enabling the BS Service configuration mode you can restore the default
values for some or all of the non-mandatory parameters.
To restore one or several BS Service parameters do their default value, run the
following command:
npu(config-bs-66053-service-video)# no def [max-dl-rtx ]
[max-ul-rtx ] [max-subburst ] [trgt-err-rate ] [paging-cycle ]
[paging-offset ] [lm-traffic-idle-period ] [dl-def-rate ]
You can restore one or several parameters to the default value(s) by specifying
only those parameter. For example, to restore only the max-dl-rtx and max-ul-rtx
parameters to their default values, run the following command:
npu(config-bs-66053-service-video)# no def max-dl-rtx max-ul-rtx
The max-dl-rtx and max-ul-rtx parameters will be restored to their default values,
while all other parameters will remain unchanged.
To restore all parameters to their default value, run the following command:
npu(config-bs-66053-service-video)# no def
Command
Modes
bs service configuration mode
NOTE
The max-subburs parameter is not relevant.
An attempt to restore the default value of the trgt-err-rate parameter will be ignored. The value of
this parameter is set by internal logic.
NOTE
Refer to Section 3.8.4.2 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-service-video)# no def [max-dl-rtx ]
[max-ul-rtx ] [max-subburst ] [trgt-err-rate ] [paging-cycle ]
[paging-offset ] [lm-traffic-idle-period ] [dl-def-rate ]
Privilege
Level
10