User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs

4Motion 465 System Manual

3.8.4.2 Configuring BS Service Parameters

From the BS configuration mode, run the following command:

npu(config-bs-66053-service-video)# def [max-dl-rtx <(0 to 15

StepSize1)> ] [max-ul-rtx <(0 to 15 StepSize 1)> ] [max-subburst

<(0 to 20000 StepSize 1)> ] [trgt-err-rate <(0.1 to 10 StepSize

0.1)> ] [paging-cycle <(6 to 1000 StepSize 1)> ] [paging-offset <(0

to 1000 StepSize 1)> ] [lm-traffic-idle-period <(50 to 60000

StepSize 50)> ] [dl-def-rate {ctcQpskOneOverTwoTimesSix |

ctcQpskOneOverTwoTimesFour | ctcQpskOneOverTwoTimesTwo |

ctcQpskOneOverTwo | ctcQpskThreeOverFour | ctcQamSixteenOneOverTwo

| ctcQamSixteenThreeOverFour | ctcQamSixtyFourOneOverTwo |

ctcQamSixtyFourTwoOverThree | ctcQamSixtyFourThreeOverFour |

ctcQamSixtyFourFiveOverSix} ]

To configure the BS Service Parameters:

NOTE

The max-subburs parameter is not relevant.

An attempt to configure the trgt-err-rate parameter will be ignored. The value of this parameter is set

by internal logic.

Command

Syntax

npu(config-bs-66053-service-video)# def [max-dl-rtx <(0 to 15

StepSize1)> ] [max-ul-rtx <(0 to 15 StepSize 1)> ] [max-subburst

<(0 to 20000 StepSize 1)> ] [trgt-err-rate <(0.1 to 10 StepSize

0.1)> ] [paging-cycle <(6 to 1000 StepSize 1)> ] [paging-offset

<(0 to 1000 StepSize 1)> ] [lm-traffic-idle-period <(50 to 60000