User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration

4Motion 131 System Manual

3.3.3.2 Displaying the AU Maintenance VLAN ID

To display the current value configured for the au maintenance VLAN ID, run the

following command:

npu# show aumaintenanceVlanId

3.3.4 Managing the NPU Boot Mode

The NPU boot mode refers to the mode of operation to be used for operating the

NPU. You can configure the NPU to be operated in any of the following boot

modes:

 ASN-GW mode: In this mode, the NPU implements ASN-GW functionalities,

that is, it implements R3 Reference Point (RP) towards the CSN, R4 reference

point toward other ASN-GWs, and R6 reference point toward AU/BSs. The R8

reference point traffic is transparently relayed between AU/BSs (intra- or

inter-shelf). The ASN-GW mode operates:

» With HA support, that is, the NPU implements Mobile IP services (MIP) Not

supported in the current release.

» Without HA support, that is, the NPU does not implement MIP services

Command

Syntax

npu# show aumaintenanceVlanId

Privilege

Level

Display

Format

aumaintenanceVlanId <value>

Command

Modes

Global command mode

IMPORTANT

The ASN-GW mode without HA support is the default boot mode that is used when the NPU boots

up for the first time.