User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration

4Motion 105 System Manual

After enabling the interface configuration mode, you can:

 Modify the physical properties of an interface (refer to Section 3.3.2.1.2)

 Manage VLAN translation (refer to Section 3.3.2.1.3)

Table 3-12: Parameters for Configuring the Interface Configuration Mode (Ethernet Interfaces)

Interface Parameter Example

Fast Ethernet <interface-t

ype>

<interface-i

npu(config)# interface fastethernet 0/8

Gigabit

Ethernet

<interface-t

ype>

<interface-i

npu(config)# interface gigabitethernet 0/9

npu(config)# interface gigabitethernet 0/10

IMPORTANT

To enable the interface configuration mode for physical interfaces, specify values for the

interface-type and interface-id parameters only. The internal-mgmt,

external-mgmt, bearer, local-mgmt parameters are used for enabling the interface

configuration mode for IP interfaces; the npu-host and all-au parameters are used for enabling

the interface configuration mode for virtual interfaces. For more information about configuring IP

interfaces, refer to

Section 3.3.2.3; refer to Section 3.3.2.4 for configuring virtual interfaces.

IMPORTANT

An error may occur if the interface type and ID that you have specified is in an invalid format or does

not exist. Refer to the syntax description for more information about the correct format for specifying

the interface type and name.

Command

Syntax

npu(config)# interface {<interface-type> <interface-id> |internal-mgmt

|external-mgmt | bearer | local-mgmt | npu-host | all-au}

Privilege

Level