User's Manual

Chapter 3 - Operation and Administration Using the CLI Using the Command Line Interface for Management
4Motion 85 System Manual
3.1.6.3.2 Returning to the Default Privilege Level
Run the following command to disable the current privilege level, and return to
your default privilege level:
npu(config)# disable [Level <0-10>]
After you run this command, you automatically return to your default privilege
level. You can display your current privilege level, using the following command:
npu# show privilege
3.1.6.4 Displaying Active Users
To display all active users, run the following command:
npu# show users
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[Level <0-10>] Indicates the privilege level
you want to enable.
Mandatory N/A 0-10
Command
Modes
Global configuration mode
Command
Syntax
npu(config)# disable [Level <0-10>]
Privilege
Level
1
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[Level <0-10>] Indicates the privilege level
you want to disable.
Mandatory N/A 0-10
Command
Modes
Global command mode