User's Manual

Chapter 3 - Operation and Administration Using the CLI Using the Command Line Interface for Management
4Motion 84 System Manual
3.1.6.3.1 Enabling a Higher Privilege Level
1 Log in to the CLI.
2 Run the following command to specify the privilege level and password:
npu(config)# enable [Level <0-10>]
3 At the password prompt, specify the password configured for the privilege level
that you have specified.
If you specify the correct password, you are logged in to the CLI with the privilege
level that you had specified. You can now execute all commands that require the
current privilege level.
You can, at any time, return to your default privilege level. For details, refer
Section 3.1.6.3.2.
To enable a higher privilege level:
NOTE
You can display your current privilege level, using the following command:
npu# show privilege
NOTE
An error may occur if:
 You have specified an incorrect password. Remember that all passwords are case-sensitive.
 No password is not configured for the privilege level you are trying to access.
Command
Syntax
npu(config)# enable [Level <0-10>]
Privilege
Level
10