User's Manual

Chapter 3 - Operation and Administration Using the CLI Using the Command Line Interface for Management
4Motion 79 System Manual
3.1.6.1 Managing Users
You can add/modify/delete one or more users for accessing the CLI either
through a local or remote terminal.
This section describes the commands for:
 “Adding/Modifying Users” on page 79
 “Deleting a User” on page 80
3.1.6.1.1 Adding/Modifying Users
To add/modify a user, and assign a username, password, and privilege level, run
the following command:
npu(config)# username <user-name> password <passwd> privilege
<0-10>
IMPORTANT
Only users who have logged in as admin can add/modify/delete users.
IMPORTANT
Only users who have logged in as admin can execute this task.
IMPORTANT
An error may occur if:
 You are not logged in as the admin.
 The username or password that you have specified is more than 20 characters.
 The privilege level that you have specified is not within the range, 0-10.
Command
Syntax
npu(config)# username <user-name> password <passwd> privilege <0-10>
Privilege
Level
10