User's Manual

Chapter 3 - Operation and Administration Using the CLI Using the Command Line Interface for Management

4Motion 71 System Manual

1 Use the MON cable to connect the MON connector of the NPU to the COM port

of your ASCII ANSI terminal or PC. The COM port connector of the Monitor

cable is a 3-pin to 9-pin D-type plug.

2 Run a terminal emulation program, such as HyperTerminal™.

3 Set the communication parameters listed in the following table:

4 The login prompt is displayed. (Press Enter if the login prompt is not

displayed.) Enter your login ID and password to log in to the CLI.

After you provide your login information, the following command prompt is

displayed:

npu#

This is the global command mode. For more information about different command

modes, refer to Section 3.1.3.

3.1.2.2 Accessing the CLI From a Remote Terminal

The procedure for accessing the CLI from a remote terminal differs with respect to

the IP connectivity mode. The Ethernet port and IP interface you are required to

configure for enabling remote connectivity is different for each connectivity mode.

For more information about connectivity modes, and Ethernet ports and IP

interface used for operating the 4Motion system, refer “Managing the IP

Connectivity Mode” on page 98.

Table 3-2: COM Port Configuration

Parameter Value

Baud rate 115200

Data bits 8

Stop bits 1

Parity None

Flow control Xon/Xoff

Port Connected COM port

NOTE

The default login ID and password are:

Password: admin123