User's Manual

Chapter 2 - Commissioning Completing the Site Configuration Using AlvariSTAR
4Motion 60 System Manual
2 In the New AU definition window, define the following:
» AU number (AU Slot)
» Type (in current release only AU 4x4 Modem is applicable)
3 Click Apply.
4 Repeat the process for all required AU entities.
2.2.4.2 ODU
ODU entities must be created for all installed ODUs (you may create an ODU
entity also for ODUs that are not installed yet).
1 Right click on the ODU node in the Navigation Pane and select Create. The
New ODU definition window will open.
2 In the New ODU definition window, define the following:
» ODU number
» ODU Type
3 Click Apply.
4 In the ODU General screen of the applicable ODU, in the Ports Configuration
section, configure the Tx Power for the relevant Tx/Rx port(s) . Click on the
Apply button for the device the accept the configuration.
5 Repeat the process for all required ODU entities.
2.2.4.3 Antenna
Antenna entities must be created for all installed and connected antennas (you
may create an Antenna entity also for antennas that are not installed/connected
yet).
1 In the Antenna screen, click on the Add New Antenna button.
2 In the Antenna Parameters section, define Antenna Product Type
To create a new ODU entity:
To create a new Antenna entity: