User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration

4Motion 255 System Manual

3.3.11.14.4 Configuring the DHCP Server/Proxy/Relay

1 Enable the service group operation mode for DHCP server/relay/proxy (refer to

Section 3.3.11.14.4.1)

2 You can now execute one of the following tasks according to the selected DHCP

mode:

» Configure the DHCP server (refer to Section 3.3.11.14.4.2)

» Configure the DHCP proxy (refer to Section 3.3.11.14.4.3)

» Configure the DHCP relay (refer to Section 3.3.11.14.4.4)

3.3.11.14.4.1 Enabling the Service Group Operation Mode for DHCP Server//Proxy/Relay

Run the following command enable the DHCP (server/relay/proxy) configuration

mode.

npu(config-srvcgrp)# config {server|proxy|relay}

When you run this command, the DHCP server/proxy/relay configuration mode is

enabled, after which you can execute the following tasks:

 Configure the DHCP server (refer to Section 3.3.11.14.4.2)

 Configure the DHCP proxy (refer to Section 3.3.11.14.4.3)

 Configure the DHCP relay (refer to Section 3.3.11.14.4.4)

Privilege

Level

Command

Modes

IP Service group configuration mode

To configure the DHCP server/proxy/relay:

NOTE

You cannot modify the configured DHCP mode. To change the DHCP mode you should first delete

the Service Group and configure it again.