User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 251 System Manual
{server|proxy|relay} |{[<acct (none|time|volumeTime)>]}|{[<ms-loop
(enable|disable)>] | [acctInterimTmr <integer(0|5-1600)>]}
This commands comprises 5 sub-commands:
1 npu(config-srvcgrp)# config {[srvcif-alias <service interface>]
[waitdhcp-holdtime <timeout>] [dhcp-ownaddr <ipv4addr>]}
2 npu(config-srvcgrp)# config {server|proxy|relay}
3 npu(config-srvcgrp)# config {[<acct (none|time|volumeTime)>]}
4 npu(config-srvcgrp)# config {[<ms-loop (enable|disable)>]}
5 npu(config-srvcgrp)# config {[acctInterimTmr <integer(0|5-1600)>]}
NOTE
You can display configuration information for the service group. For details, refer to
Section 3.3.11.15.2.
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.
Command
Syntax
npu(config-srvcgrp)# config {{[srvcif-alias <service interface>]
[waitdhcp-holdtime <timeout>] [dhcp-ownaddr <ipv4addr>]} |
{server|proxy|relay} |{[<acct (none|time|volumeTime)>]}|{[<ms-loop
(enable|disable)>] | [acctInterimTmr <integer(0|5-1600)>]}
Privilege
Level
10