User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 246 System Manual
3.3.11.13.2.3 Displaying Global RADIUS Configuration Parameters
To display global RADIUS configuration parameters used for all AAA clients, run
the following command:
npu# show radius
3.3.11.14 Managing Service Groups
A service group is a group of MSs that are served by the same service provider or
service flows that belong to the same service class.
The following service group types are supported:
 IP: This type of service group is used only for IP CS flows. Once service group
is configured as type IP, additional IP allocation configuration is also required
(such as DHCP mode, IP pool, IP Subnet, etc). This type of service group must
be associated with either IP-IP (encapsulated IP packets) or VLAN type of R3
service interface. An IP service group can be configured to support time based
or volume and time based accounting. In addition, an IP service group can be
Command
Modes
Global configuration mode
Command
Syntax
npu# show radius
Privilege
Level
1
Display
Format
TimeOut <value>
accessReq-retries <value>
NAS-ID <value>
TimeZone Offset <value>
framed MtuSize <value>
Profile AtrbtType <value>
alrmAaaSwitchoverRetryFailThrshld <value>
Command
Modes
Global command mode