User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 241 System Manual
3.3.11.13.1.2 Configuring Parameters for the AAA Client
After enabling the AAA client configuration mode, run the following command to
configure the parameters for the AAA client:
npu(config-aaa)# config ([src-intf <ip-intf>] [primary-serveraddr
<ipv4addr>] [rad-sharedsecret <string>] [rad-CallingStationId
{Binary | UTF-8}])
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.
IMPORTANT
If the bearer interface IP address is being modified after aaa-client configuration, you must
re-configure the src-intf parameter to "bearer" so that the aaa-client will attach itself to the new
bearer interface IP address.
Command
Syntax
npu(config-aaa)# config ([src-intf <ip-intf>] [primary-serveraddr
<ipv4addr>] [rad-sharedsecret <string>] [rad-CallingStationId {Binary |
UTF-8}])
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[src-intf
<ip-intf>]
Indicates the interface
providing RADIUS client
functionality. Must be the
bearer interface.
Optional bearer bearer
[primary-serve
raddr
<ipv4addr>]
Denotes IPv4 address of the
primary AAA server (in the
current release an alternate
server is not supported).
Mandatory 172.16.0
.10
Valid IP
Address