User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 234 System Manual
3.3.11.12.3 Restoring the Default Configuration Parameters for a Service Interface
This section describes the commands for:
 “Restoring the Default Configuration Parameters for an IP-IP Service Interface”
 “Restoring the Default Configuration Parameters for a VLAN Service Interface”
3.3.11.12.3.1 Restoring the Default Configuration Parameters for an IP-IP Service Interface
Run the following command to restore the default configuration for IP-IP service
interface tun-mtu and/or tun-chksm parameters:
npu(config-srvcif-ipip)# no tunnel [mtu] [chksm]
You can restore only one parameter to its default values by specifying only that
parameter. To restore both parameters to their default value, run the command
npu(config-srvcif-ipip)# no tunnel.
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
descr <string>
A description of the service
interface.
Optional null String (up to 70
characters)
vlan-id
<size(1-4094>]
A Service Interface VLAN ID
shall not conflict with other
instances of Service Interface
VLAN ID and VLAN IDs of
Bearer, Local-Management
and External-Management
interaces. Shall also not
conflict with CVID of any
transparent MS.
Note that the default (0) is not
a valid value.
Optional 0 1-9, 11-4094
Command
Modes
QinQ Service Interface configuration mode