User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 233 System Manual
3.3.11.12.2.3 Configuring Parameter for QinQ Service Interface
After enabling the QinQ Service Interface configuration mode, run the following
command to configure the QinQ service interface parameters:
This command shall configure one or more parameters of the QinQ Service
Interface.
npu(config-srvcif-QinQ)# config ([descr <string>] [vlan-id <size(1-4094>])
[dflt-gw-ip <ip
address>
<mask>]
The IP Address and subnet
mask of the Default Gateway.
The IP address shall be
unique among all the Host
Interfaces IP's (Bearer,
Local-Management,
Internal-Management,
External-Management) and
existing instances of Service
Interface’s Tunnel Destination
IP Address and Default
Gateway IP Address.
Interface mask should be
configured in such a way that
the resulting subnet should
not overlap with an existing
Interface subnet (host
interfaces, other service
interfaces).
Should be in the same
subnet.with the IP Address of
the DHCP server/proxy/relay
to be assigned to a service
group using this service
interface.
Mandatory N/A valid IP
address and
mask
[mtu
<size(556-1804
)>]
The MTU size in bytes Optional 1480 556-1804
Command
Modes
VLAN Service Interface configuration mode
Command
Syntax
npu(config-srvcif-QinQ)# config ([descr <string>] [vlan-id <size(1-4094>]])