User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 232 System Manual
3.3.11.12.2.2 Configuring Parameters for VLAN Service Interface
After enabling the VLAN Service Interface configuration mode, run the following
command to configure the VLAN service interface parameters:
This command shall configure one or more parameters of the VLAN Service
Interface.
npu(config-srvcif-vlan)# config ([descr <string>] [vlan-id <size(1-9|11-4094>]
[dflt-gw-ip <ipaddress> <mask>] [mtu <size(556-1804)>])
[chksm]
Indicates that end-to-end
checksumming mechanism
on ServiceTunnel Interface is
enabled.
Optional By
default,
this
feature
is
disabled.
The
presence/abse
nce of this flag
indicates that
this feature is
enabled/
disabled.
Command
Modes
IP-IP Service Interface configuration mode
Command
Syntax
npu(config-srvcif-vlan)# config ([descr <string>] [vlan-id <size(1-9|11-4094>]
[dflt-gw-ip <ip address> <mask>] [mtu <size(556-1804)>])
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
descr <string>
Aa description of the service
interface.
Optional null String (up to 70
characters)
vlan-id
<size(1-9|11-4
094>]
A Service Interface VLAN ID
shall not conflict with other
instances of Service Interface
VLAN ID and VLAN IDs of
Bearer, Local-Management,
External-Management and
AU Maintenance interfaces.
Shall also not conflict with
CVID of any transparent MS
with L2 service.
Mandatory N/A 1-9, 11-4094