User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 231 System Manual
 “Configuring Parameters for IP-IP Service Interface”
 “Configuring Parameters for VLAN Service Interface”
3.3.11.12.2.1 Configuring Parameters for IP-IP Service Interface
After enabling the IP-IP Service Interface configuration mode, run the following
command to configure the IP-IP service interface parameters:
This command shall configure one or more parameters of the IP-IP Service
Interface.
npu(config-srvcif-ipip)# config tunnel ([descr <string>] [srcaddr <ip4addr>]
{dstaddr <ipv4addr>} [mtu <size(556-1804)>] [chksm])
Command
Syntax
npu(config-srvcif-ip-ip)# config tunnel ([descr <string>] [srcaddr <ip4addr>]
{dstaddr <ipv4addr>} [mtu <size(556-1804)>] [chksm])
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[descr <string>]
A description of the Service
Interface.
Optional null String (up to 70
characters)
[srcaddr
<ip4addr>]
The source IP address that
indicates the point of
origination of the tunnel for
the service interface.
Must be the same as the
Bearer IP Address.
Mandatory N/A IP Address of
Bearer
Interface.
{dstaddr
<ipv4addr>}
The destination IP address
that indicates the point of
termination of the tunnel for
the service interface.
Mandatory N/A Valid IP
Address.
[mtu
<size(556-1804
)>]
Denotes the MTU. Optional 1480 556-1804