User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 230 System Manual
After enabling the configuration mode for a Service Interface you can execute any
of the following tasks:
 Configure one or more of the Service Interface parameters (refer to
Section 3.3.11.12.2)
 Restore the default values of non-mandatory parameters of the Service
Interface (refer to Section 3.3.11.12.3)
After executing the above tasks, you can terminate the Service Interface
configuration mode (refer to Section 3.3.11.12.4) and return to the global
configuration mode.
3.3.11.12.2 Configuring Service Interface Parameters
This section describes the commands for:
Command
Syntax
npu(config)# srvc-intf [<string>] [{IP-IP|VLAN|QinQ}]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[<string>]
The Service Interface alias of
the Service Interface for
which you want to enable the
configuration mode. If you
want to create a new Service
Interface, specify a new alias
and define the type of service
interface (see below).
Mandatory N/A String (1 to 30
characters)
[{IP-IP|VLAN
|QinQ}]
The Service Interface’s type. Optional IP-IP
 IP-IP
 VLAN
 QinQ
Command
Modes
Global configuration mode