User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 229 System Manual
1 Enable the Service Interface configuration mode for the selected Service
Interface (refer to Section 3.3.11.12.1)
2 You can now execute any of the following tasks:
» Configure one or more of the parameters of the Service Interface (refer to
Section 3.3.11.12.2)
» Restore the default values of the Service Interface parameters (refer to
Section 3.3.11.12.3)
» Terminate the Service Interface configuration mode (refer to
Section 3.3.11.12.4)
In addition, you can, at any time, display configuration information for one or all
existing Service Interfaces (refer to Section 3.3.11.12.6) or delete an existing
Service Interface (refer to Section 3.3.11.12.5).
3.3.11.12.1 Enabling the Service Interface Configuration Mode\Creating a Service
Interface
To configure the parameters of a Service Interface, first enable the Service
Interface configuration mode for the specific Service Interface. Run the following
command to enable the Service Interface configuration mode. You can also use
this command to create a new Service Interface.
npu(config)# srvc-intf [<string>] [{IP-IP|VLAN|QinQ}]
For example, to define a new IP-IP Service Interface named SI1, run the following
command:
npu(config)# srvc-intf SI1 IP-IP
To enable the configuration mode for an existing Service Interface named SI1, run
the following command:
npu(config)# srvc-intf SI1
If you use this command to create a new Service Interface, the configuration mode
for this Service Interface is automatically enabled.
To configure a Service Interface:
NOTE
The Bearer IP Interface (refer to “Configuring IP interfaces” on page 118) must be
configured prior to creating IP-IP or VLAN service interfaces.