User's Manual

ManualsBrandsAlvarion Technologies ManualsElectronicsBreezeMAX 4Motion Broadband Wireless Access System

Chapter 3 - Operation and Administration Using the CLI NPU Configuration

4Motion 225 System Manual

3.3.11.11.3 Restoring the Default Configuration Parameters for the Bearer Plane

QoS Output Marking Rules

Run the following command to restore the default configuration for this bearer

plane QoS marking rule:

npu(config-bqos)# no {outer-dscp | vlan-priority | qos enable}

When you execute this command, it automatically disables this QoS marking rule.

[qos enable] Indicates whether this QoS

marking rule should be

enabled. The absence of this

flag indicates that this QoS

flag is disabled. By default, a

bearer plane QoS marking

rule is disabled.

If you enable this QoS

marking rule, packets on

bearer plane that were

created using the parameters

Section 3.3.11.11.1,

the Outer DSCP and VLAN

Priority fields in the IP header

and Ethernet header,

respectively are populated

with the values you specify for

the outer-dscp and

vlan-priority

parameters.

Optional By

default,

the QoS

marking

rule is

disabled.

The

presence/abse

nce of this flag

indicates that

this QoS flag is

enabled/disabl

ed.

Command

Modes

Bearer plane QoS marking rules configuration mode

NOTE

Refer to Section 3.3.11.11.2 for a description and default values of these parameters.

Command

Syntax

npu(config-bqos)# no

{outer-dscp | vlan-priority | qos enable}

Privilege

Level