User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 216 System Manual
3.3.11.8 Managing the Context Function
The context function manages the contexts of various authenticated MSs. You can
specify parameters pertaining to context creation and reports.
Context function parameters can be configured only by the vendor.
To display configuration information for the context function, run the following
command:
npu# show contextfn
The following table provides some details on these parameters:
dpTimerPathRegRsp The period, in milliseconds, within which the NPU should wait for an
acknowledgement for the registration response. If a response is not
received within this period, the NPU retransmits the response.
dpCounterPathRegRspMax The maximum number of times the NPU may retransmit the path response.
pdpTimerPathRegStart Indicates the period, in milliseconds, within which the path registration
procedure is initiated, after the path pre-registration procedure is complete.
If the path registration procedure is not completed within the period
specified by this parameter, the MS is de-registered.
dpTimerMipWaitDhcp The period, in seconds, for allocating the IP address, after the path
registration procedure is complete.
Command
Syntax
npu# show contextfn
Privilege
Level
1
Display
Format
Context Function Configuration :
ctxtfnTimerContextReq <value>
ctxtfnCounterContextReqMax <value>
ctxtfnTimerContextRprt <value>
ctxtfnCOUNTerContextRprtMax <value>
Command
Modes
Global command mode