User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 213 System Manual
The following table provides some details on these parameters:
Display
Format
Authenticator Function Configuration :
e
eapTimerIdReq <value>
eapCounterIdReqMax <value>
authTimerNtwEntryHold <value>
eapTimerTransfer <value>
eapCounterTransferMax <value>
eapCounterReAuthAttemptMax <value>
authTimerReauthCmpltHold <value>
eapCounterRndTripsMax <value>
authTimerPmkLifetime <value>
authTimerPmkGaurd <value>
authCounterNtwEntryMax <value>
authTimerAuthFailureHold <value>
Command
Modes
Global command mode
Parameter Description
eapTimerIdReq The period, in milliseconds, the NPU waits for the EAP Transfer response.
eapCounterIdReqMax The period, in milliseconds, for which the NPU should wait for the
response to the request for the EAP ID.
authTimerNtwEntryHold The period, in seconds, within which the MS should be authenticated for
initial entry into the network. If the MS is not authenticated within this
period, the NPU terminates the request for network entry.
eapTimerTransfer The maximum number of times the MS can attempt for initial entry to the
network. If the number of EAP transfers exceeds the value of this
parameter, the NPU de-registers the MS.
eapCounterTransferMax The number of times the NPU can retransmit the EAP ID request until it
receives a EAP ID response.