User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 337 System Manual
3.3.11.16.3 Terminating the PHS Rules Configuration Mode
Run the following command to terminate the PHS rules configuration mode:
npu(config-phsrule)# exit
3.3.11.16.4 Deleting PHS Rules
Run the following command to delete one or all PHS rules:
npu(config)# no phs-rule [<rulename>]
Command
Modes
PHS rules configuration mode
Command
Syntax
npu(config-phsrule)# exit
Privilege
Level
10
Command
Modes
PHS rules configuration mode
CAUTION
Specify the rule name if you want to delete a specific PHS rule. Otherwise all the configured PHS
rules are deleted.
Command
Syntax
npu(config)# no phs-rule [<rulename>]
Privilege
Level
10