User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 335 System Manual
3.3.11.16.2 Configuring Parameters for the PHS Rule
Run the following command to configure the parameters of the PHS rule:
npu(config-phsrule)# config <[field <value>] [mask <value>] [verify
<value>] [size <value>]>
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<rulename> Denotes the PHS rule for
which the PHS configuration
mode is to be enabled.
Mandatory N/A String (1 to 30
characters)
Command
Modes
Global configuration mode
NOTE
You can display configuration information for specific or all PHS rules. For details, refer
Section 3.3.11.16.5.
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.
Command
Syntax
npu(config-phsrule)# config <[field <value>] [mask <value>] [verify
<value>
] [size <value>]>
Privilege
Level
10