User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 328 System Manual
3.3.11.15.4.8.4Terminating the Destination Port Configuration Mode
Run the following command to terminate the destination port configuration mode:
npu(config-clsfrule-dstport)# exit
3.3.11.15.4.8.5Deleting Destination Ports
Run the following command to delete one or all destination ports
npu(config-clsfrule)# no dstport [<start-port> <end-port>]
Command
Syntax
npu(config-clsfrule-srcport)# no port-enable
Privilege
Level
10
Command
Modes
L3 Classification rules-destination port configuration mode
Command
Syntax
npu(config-clsfrule-dstport)# exit
Privilege
Level
10
Command
Modes
L3 Classfication rule-destination port configuration mode
IMPORTANT
An error may occur if you provide an invalid value for the start-port and end-port parameters.
Refer the syntax description for more information about the appropriate values and format for
configuring these parameters.
Command
Syntax
npu(config-clsfrule)# no dstport [<start-port> <end-port>]
Privilege
Level
10