User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 327 System Manual
3.3.11.15.4.8.2Enabling the Destination Port Range
You can run the following command to enable the destination port range:
npu(config-clsfrule-dstport)# port-enable
You can also run this command to enable a destination port range that is
currently disabled. For details, refer to “Disabling the Destination Port Range” on
page 327.
3.3.11.15.4.8.3Disabling the Destination Port Range
You can run the following command to disable the destination port range that is
currently enabled:
npu(config-clsfrule-dstport)# no port-enable
Command
Modes
L3 Classification rules configuration mode
IMPORTANT
If destination port range is enabled, then:
IP protocol (protocol-enable) is set to enabled.
Protocol can be either 6 (TCP) or 17 (UDP).
For details on these parameters refer to Section 3.3.11.15.4.4.2.
Command
Syntax
npu(config-clsfrule-dstport)# port-enable
Privilege
Level
10
Command
Modes
L3 Classification rules-destination port configuration mode
IMPORTANT
To enable this destination port range, run the following command:
npu(config-clsfrule-dstport)# port-enable
For details, refer to
“Enabling the Destination Port Range” on page 327.