User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 320 System Manual
3.3.11.15.4.6.4Terminating the Destination Address Configuration Mode
Run the following command to terminate the destination address configuration
mode:
npu(config-clsfrule-dstaddr)# exit
3.3.11.15.4.6.5Deleting Destination Addresses
You can, at any time, run the following command to delete one or all destination
addresses
npu(config-clsfrule)# no dstaddr [<ip-Addr>]
Command
Syntax
npu(config-clsfrule-dstaddr)# exit
Privilege
Level
10
Command
Modes
L3 Classfication rule-destination address configuration mode
IMPORTANT
An error may occur if you provide an invalid IP address. Refer the syntax description for more
information about the appropriate values and format for configuring this parameter.
Command
Syntax
npu(config-clsfrule)# no dstaddr [<ip-Addr>]
Privilege
Level
10