User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 310 System Manual
3.3.11.15.4.4.3Disabling Protocol Lists
After enabling the protocol configuration mode, run the following command to
disable one or more IP protocol lists:
npu(config-clsfrule-protocol)# no protocol-enable <number of
protocols(1-6)> <protocol1> [<protocol2>] [...]
<protocol1>
[<protocol2>]
[...]
Indicates the IP protocols to
be enabled. In the current
release, only one protocol
can be enabled per
classification rule.
Mandatory N/A 0-255 (Using
standard IANA
protocol
values)
Command
Modes
L3 Classification rules-IP protocol configuration mode
Command
Syntax
npu(config-clsfrule-protocol)# no protocol-enable <number of
protocols(1-6)> <protocol1> [<protocol2>] [...]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<number of
protocols(1-6)
>
Indicates the number of
protocol lists to be disabled.
In the current release, only
one protocol can be enabled
per classification rule.
Mandatory N/A 1
<protocol1>
[<protocol2>]
[...]
Indicates the protocols to be
disabled. You are required to
specify at least one protocol
that is to be disabled.
In the current release, the
single previously enabled
protocol should be defined.
Mandatory N/A 0-255