User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 309 System Manual
3.3.11.15.4.4.2Enabling Protocol Lists
After enabling the protocol configuration mode, run the following command to
enable one or more IP protocol lists:
npu(config-clsfrule-protocol)# protocol-enable <number of
protocols(1-6)> <protocol1> [<protocol2>] [...]
Command
Syntax
npu(config-clsfrule)# ip-protocol
Privilege
Level
10
Command
Modes
L3 Classification rules configuration mode
IMPORTANT
If destination port range (see Section 3.3.11.15.4.8.2) is enabled, then:
IP protocol (protocol-enable) is set to enabled.
Protocol can be either 6 (TCP) or 17 (UDP).
Command
Syntax
npu(config-clsfrule-protocol)# protocol-enable <number of protocols(1-6)>
<protocol1> [<protocol2>] [...]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<number of
protocols(1)>
Indicates the number of
protocol lists to be enabled. In
the current release, only one
protocol can be enabled per
classification rule.
Mandatory N/A 1