User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 306 System Manual
Command
Syntax
npu(config-clsfrule)# config [priority <priority(0-255)>] [phs-rulename
<rulename>
] [iptos-low <value(0-63)>] [iptos-high <value(0-63)>]
[iptos-mask <value(0-63)>] [iptos-enable]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[priority
<priority(0-25
5)>]
Denotes the priority level to
be assigned to the
classification rule.
Optional 0 0-255
[phs-rulename
<rulename>]
Indicates the Packet Header
Suppression (PHS) rule name
to be associated with the
classification rule. Specify the
PHS rulename if you want to
perform PHS for this flow. For
more information about
configuring PHS rules, refer
Section 3.3.11.16.
Optional None String
An existing
PHS rule
name.
[iptos-low
<value(0-63)>]
Denotes the value of the
lowest IP TOS field to define
the lowest value where the
range can begin.
Cannot be higher than
iptos-high.
Can be modified only when IP
TOS classification is disabled
(see iptos-enable below). If
set to a value higher than
iptos-high, IP TOS
classification cannot be
enabled.
Optional 0 0-63