User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 296 System Manual
3.3.11.15.3.3.6Terminating the Service Flow Configuration Mode
Run the following command to terminate the service flow configuration mode:
npu(config-srvcprfl-flow)# exit
Command
Syntax
npu(config-srvcprfl-flow)# no ulclsf-rulename [<num_of_rulenames (1-6)>
<rulename> [<rulename>] ...]
npu(config-srvcprfl-flow)# no dlclsf-rulename [<num_of_rulenames (1-6)>
<rulename> [<rulename>] ...]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[<num_of_rulen
ames (1-6)>
Indicates the number of
uplink/downlink classification
rules to be deleted.
Mandatory N/A 1-6
<rulename>
Indicates the name of the
uplink/downlink classification
rule to be deleted from to this
service flow. Use the
classification rule name to
reference the appropriate
classification rule.
The number of rule name
entries must match the
number defined in
num_of_rule_names.
Mandatory N/A Valid
classification
rule name
Command
Modes
Service profile-service flow configuration mode
Command
Syntax
npu(config-srvcprfl-flow)# exit