User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 293 System Manual
3.3.11.15.3.3.3Restoring the Default Service Flow Configuration Parameters
Run the following command to restore the default values of one or several
parameters for this service flow:
npu(config-srvcprfl-flow)# no [cs-type] [media-type]
[uldatadlvry-type] [ulqos-maxsustainedrate]
[ulqos-trafficpriority] [dldatadlvry-type]
[dlqos-maxsustainedrate] [dlqos-trafficpriority][ul-rsrv-rate-min]
[ul-latency-max] [ul-tolerated-jitter] [ul-unsol-intrvl]
[dl-rsrv-rate-min] [dl-latency-max] [dl-tolerated-jitter]
Do not specify any parameter to restore all parameters to their default values.
3.3.11.15.3.3.4Configuring Uplink/Downlink Classification Rule Names
After enabling the service flow configuration mode, run the following commands to
configure up to a maximum of 6 uplink and 6 downlink classification rules:
npu(config-srvcprfl-flow)# ulclsf-rulename <num_of_rule_names
(1-6)> <rulename> [<rulename>] [...]
npu(config-srvcprfl-flow)# dlclsf-rulename <num_of_rule_names
(1-6)> <rulename> [<rulename>] [...]
Command
Modes
Service profile-service flow configuration mode
NOTE
Refer to Section 3.3.11.15.3.3.2 for a description and default values of these parameters.
Command
Syntax
npu(config-srvcprfl-flow)#
no [cs-type] [media-type]
[uldatadlvry-type] [ulqos-maxsustainedrate]
[ulqos-trafficpriority] [dldatadlvry-type]
[dlqos-maxsustainedrate]
[dlqos-trafficpriority][ul-rsrv-rate-min] [ul-latency-max]
[ul-tolerated-jitter] [ul-unsol-intrvl] [dl-rsrv-rate-min]
[dl-latency-max] [dl-tolerated-jitter]
Privilege
Level
10
Command
Modes
Service profile-service flow configuration mode