User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 288 System Manual
3.3.11.15.3.3.2Specifying Service Flow Configuration Parameters
After enabling the service flow configuration mode, run the following command to
configure the parameters for this service flow:
npu(config-srvcprfl-flow)# config ([flow-type <type (1)>] [cs-type
<type (1 | 4)>] [media-type <string>] [uldatadlvry-type
<type(0<UGS> | 1<RTVR> | 2<NRTVR> | 3<BE> | 4<ERTVR> | 255<ANY>)>]
[ulqos-maxsustainedrate <value(10000-40000000)>]
[ulqos-trafficpriority <value(0-7)>] [dldatadlvry-type
<type(0<UGS> | 1<RTVR> | 2<NRTVR> | 3<BE> | 4<ERTVR> | 255<ANY>)>]
[dlqos-maxsustainedrate <value(10000-40000000)>]
[dlqos-trafficpriority <value(0-7)>] [ul-rsrv-rate-min
<integer(0-40000000)>] [ul-latency-max <integer>]
[ul-tolerated-jitter <integer)>] [ul-unsol-intrvl
<integer(0-65535)>] [dl-rsrv-rate-min <integer(0-40000000)>]
[dl-latency-max <integer>] [dl-tolerated-jitter <integer>])
[grp-alias
<srvc-grp-al
ias>]
Indicates the Reference
Name for an existing service
group to be used by the
service flow.
VPWS Service Groups are
applicable only for VLAN CS
Service Flows of the Default
Service Profile.
Mandatory
when
creating a
new flow
N/A An existing
Service Group
Alias.
[if-alias
<string>]
Indicates the Reference
Name for an existing QinQ
service interface.
Applicable only if the
assigned Service Group is of
type VPWS-QinQ (in a
VLANCS Service Flow of the
Default Service Profile).
Mandatory
when
creating a
new flow,
only if the
type of the
specified
grp-alias is
VPWS-QinQ.
N/A An existing
QinQ Service
Interface.
Command
Modes
Service profile configuration mode
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.