User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 284 System Manual
If you use this command to create a new service profile, the configuration mode
for this rule is automatically enabled, after which you can execute any of the
following tasks:
 Configure the parameters for this service profile (refer to Section 3.3.11.15.3.2)
 Manage service flow configuration for this service profile (refer to
Section 3.3.11.15.3.3)
 Delete service flows (refer to Section 3.3.11.15.3.3.7)
After you have executed these tasks, terminate the service profile configuration
mode (refer to Section 3.3.11.15.3.4) to return to the service group configuration
mode.
NOTE
The dgwPrfl option is for future use. Do not use this option. In the rest of this
section this option will be ignored.
Command
Syntax
npu(config)# srvc-profile <profile-name>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<profile-name> Denotes the name of the
service profile for which the
configuration mode is to be
enabled.
If you are creating a new
service profile, specify the
name of the new service
profile. The configuration
mode is automatically
enabled for the new service
profile.
Mandatory N/A String (1 to 30
characters)