User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 282 System Manual
3.3.11.15.2 Displaying Configuration Information for the SFA PHS Functionality
To display the current configuration information for the SFA PHS functionality,
run the following command:
npu# show sfa
3.3.11.15.3 Configuring Service Profiles
The NPU allows for guaranteed end-to-end QoS for user traffic across the ASN.
The QoS approach is connection-oriented, whereby user traffic is classified into
"service flows." A service flow is a unidirectional stream of packets, either in the
downlink or uplink direction, associated with a certain set of QoS requirements
NOTE
You can display configuration information for the SFA functionality. For details, refer
Section 3.3.11.15.2.
For details on PHS Rules, refer to “Configuring PHS Rules” on page 333.
Command
Syntax
npu(config)# sfa phs-enable
npu(config)# no sfa phs-enable
Privilege
Level
10
Command
Modes
Global configuration mode
Command
Syntax
npu# show sfa
Privilege
Level
1
Display
Format
SFA Configuration :
PHS <Enable/Disable>
Command
Modes
Global command mode